MATLAB Answers

How to implement Hermite spline in Simulink

조회 수: 24(최근 30일)
MARCO LORENZI
MARCO LORENZI 2021년 9월 22일 6:43
편집: MARCO LORENZI 2021년 9월 24일 10:40
Good morning everyone.
Can i ask if it there is a way to implement the Hermite spline (pchip) or Bezier curves in simulink?
In particular, i am using a look-up table to interpolate a curve between some point, but the cubic and akima splines don't do a good job. I was thinking about using a linear interpolating method and then smoothen up the curves, but i can't find any blockset.
Thank you very much in advance.

채택된 답변

Bjorn Gustavsson
Bjorn Gustavsson 2021년 9월 22일 7:27
There is a way to make blocks that wrap a matlab-function (matlab-functions-simulink_5), shouldn't that solve this task?
HTH
  댓글 수: 5
Bjorn Gustavsson
Bjorn Gustavsson 2021년 9월 24일 6:31
To me it seems as you swapped the x and xq in the function. It ought to be:
function output = low_angles_Hermite_approximation(phase)
xq = phase;
y = [0 0 0 0 0 0 0 1 1];
x = [0 2.5 5 7.5 10 13 15 30 90];
output = pchip(x,y,xq);
When you program and run into errors like these read the help and documentation carefully - and calmly, far to often it is easy to rush that part. Also be prepared to use the debug-facilities of matlab, I typically turn on debug-stop after an error:
>> dbstop if error
Then you get a command-line prompt at the line where the error occurred with command-line access to all variables in the function and it is possible to step up in the function call-stack.

댓글을 달려면 로그인하십시오.

추가 답변(0개)

태그

제품


릴리스

R2020b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by