Model simulink block connection with different simscape
이전 댓글 표시
I am trying to connect a converter model to a grid model. The problem is the grid model was created in old matlab version by using PowerSimSystem. The pictures show how it does not allow me to connect the switch (out side the subsystem) to the current sensor(inside subsystem). Is there any solution for this situation? Any suggestion for another blocks that I could use instead or with my model.


댓글 수: 2
SALAH alatai
2021년 8월 18일
Because the blue line one and the black one from different library can't connect them together, try to find the same block from same library.
Rawaa Almajeez
2021년 8월 18일
채택된 답변
추가 답변 (1개)
Dr. Pemendra Kumar Pardhi
2021년 8월 18일
1 개 추천
Dear You can connect single phase voltage source from simelectrical-specialized technology- source. In between port 1 and 2 as shon your figure
댓글 수: 3
Rawaa Almajeez
2021년 8월 18일
Dr. Pemendra Kumar Pardhi
2021년 8월 18일
Dear Rawaa Almajeez
I have upload the model on Mathwork for grid connected single phase PV system.
here i have used single phase source as a utility grid, you can downolad it via given linke below
Rawaa Almajeez
2021년 8월 18일
커뮤니티
더 많은 답변 보기: Power Electronics Community
카테고리
도움말 센터 및 File Exchange에서 Get Started with Simscape Electrical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!