Using only one USRP & PC to transmit and receive the data at the same time
조회 수: 10 (최근 30일)
이전 댓글 표시
I am new to both Simulink and USRP hardware. Basically, what I am trying to do is just to send and receive the data using only one USRP n210. I have created a transmitter and receiver block separately. Transmitter could work fine and show the correct waveform when connecting to the oscilloscope. And receiver block could also will work if USRP is connected directly by a real signal generator. But when I tried to put transmitter and receiver block together, the oscilloscope showed nothing and the vector scope inside my model will only show some noise. There is not much examples about using Simulink to work with USRP hardware. Thanks for any help and answer.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/163100/image.png)
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/163103/image.png)
댓글 수: 0
답변 (3개)
Lin Khine
2015년 4월 2일
Can you please kindly tell me how did you enable overrun port in SDRu receiver?
댓글 수: 0
Lin Khine
2015년 4월 2일
Can I see the result of vector scopes for each transmitter and receiver?
댓글 수: 0
John Rodgers
2016년 1월 27일
Hi, Did you succeed to transmit and receive at the same time ? Regards, John
참고 항목
카테고리
Help Center 및 File Exchange에서 Communications Toolbox에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!