How to respond to following message which is obtained while trying to generate the bitstream file of a simulink file including xilinx blocks? Please guide me.

Question

vanama namasivayam 2014년 1월 3일

0
링크

이 질문에 대한 바로 가기 링크

https://kr.mathworks.com/matlabcentral/answers/111333-how-to-respond-to-following-message-which-is-obtained-while-trying-to-generate-the-bitstream-file-of

답변: vanama namasivayam 2014년 9월 6일

INFO:ProjectMgmt - Parsing design hierarchy completed successfully.

INFO:TclTasksC:2116 - The automatic calculation of top has been turned-off.

   Please set the new top explicitly by running the "project set top" command.
   To re-calculate the new top automatically, set the "Auto Implementation Top"
   property to true.

댓글 수: 0
이전 댓글 -2개 표시이전 댓글 -2개 숨기기

댓글을 달려면 로그인하십시오.

이 질문에 답변하려면 로그인하십시오.

Answer 1

Chandrajit Pal 2014년 7월 2일

0
링크

이 답변에 대한 바로 가기 링크

https://kr.mathworks.com/matlabcentral/answers/111333-how-to-respond-to-following-message-which-is-obtained-while-trying-to-generate-the-bitstream-file-of#answer_143376

I am getting the same problem...did u get ur error solved?

댓글 수: 0
이전 댓글 -2개 표시이전 댓글 -2개 숨기기

댓글을 달려면 로그인하십시오.

Answer 2

vanama namasivayam 2014년 9월 6일

0
링크

이 답변에 대한 바로 가기 링크

https://kr.mathworks.com/matlabcentral/answers/111333-how-to-respond-to-following-message-which-is-obtained-while-trying-to-generate-the-bitstream-file-of#answer_150932

When I got this err, In the report file after partial bit stream generation is over I got another err. mentioned about the size being too large to fit into the device.So I got the successful bit stream file after reducing the device utilization but I could not follow anything about the err. what I mentioned.