How to display UNICODE/IPA characters within GUIs and plots?
조회 수: 8 (최근 30일)
이전 댓글 표시
I need to build GUIs and plots showing unicode characters and/or IPA fonts. How to do this? Please tell me step by step. Kind regards. Francesco
댓글 수: 0
답변 (3개)
Walter Roberson
2013년 11월 22일
Unfortunately, unless you draw the characters individually (or bitmap them into place), then all that you can access are the characters up to 255, together with whatever is supported in latek (such as greek characters)
댓글 수: 0
Francesco Sigona
2013년 11월 22일
편집: Walter Roberson
2013년 12월 8일
댓글 수: 4
Walter Roberson
2013년 12월 8일
I have not managed to figure it out. I did download the fonts and installed them, and can see them in the font list, but I cannot figure out how to activate the alternative symbols. (Note: I was working on OS-X, not MS Windows)
Constantino Carlos Reyes-Aldasoro
2019년 12월 6일
Hello.
This may seem rather simple but it *works*, you can just copy-paste the symbols from a webpage, for instance
https://en.wikipedia.org/wiki/International_Phonetic_Alphabet_chart
directly to the matlab editor and place each symbol inside a cell, i.e.
phoneticSymbols = {'I','ɮ','ɳ̊'};
And that works fine. HOWEVER, this does not work cross-platform, so if you work in windows, will not work in Mac and vice versa. I am not an expert in phonetics so not sure if the symbols are accurate, but to my untrained engineer eye, they look fine, see the example below.
댓글 수: 1
Walter Roberson
2019년 12월 6일
This only works for r2014b or later and when Interpreter is tek or none. It does not work for interpreter latek.
참고 항목
카테고리
Help Center 및 File Exchange에서 Migrate GUIDE Apps에 대해 자세히 알아보기
제품
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!