problem with real time udp in xPC target 5.5 when using the Intel-Gigabit ethernet adapter

조회 수: 1(최근 30일)
fatima
fatima 2013년 11월 21일
댓글: Xikai 2017년 10월 13일
hello! I have two network adapters in my xPC target which both of them are Intel-Gigabit(82540EM). when I try to boot the system and load my model on target machine, I have no problem. but when I run the model, It stopped in running mode and the connection between host and target failed. (TCP/IP connection disconnected). I check the setting of the network configuration and set it's parameters as follows: IP address : 192.168.4.105 subnet Mask : 255.255.255.0 Gateway : 192.168.4.1 Ethenet driver : Intel Gigabit PCI bus: 2 Slot: 3 when I changed the secondary adapter card and useed a 8255x card, program was completely executed and had no problem. but I need to use Intel-Gigabit as a secondary adapter. Is there any way to configure the system(software and hardware) where I will be able to use an Intel-Gigabit as a secondary card in real time udp applications? Is it possible to exist any inconsistency between my network adapters and other hardwares in my system(like mother board, ram ...)? Can you prefer any hardware setup for optimum performance in the applications that real-time udp is needed? best regards.

답변(1개)

Rajiv Ghosh-Roy
Rajiv Ghosh-Roy 2013년 12월 6일
I think both your host-target communication and real-time UDP are trying to use the same card. For diagnostics, I would try the following steps:
  • Make sure the bus and slot displayed at boot time (which is the one used by the host-target communication) is different from the one you specify in your model for real-time UDP.
  • You may have to experiment with disconnecting/reconnecting Ethernet cables and seeing which functionality (host/target or real-time UDP) still works to identify the cards. Bus 2, Slot 3 or similar tells us the identification of the card on the bus, but not the physical location.
  댓글 수: 2
Xikai
Xikai 2017년 10월 13일
Does Intel-Gigabit(82540EM) support real-time UDP in xPC target? It's the question.

댓글을 달려면 로그인하십시오.

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by