How to make figure appear within defined axes of guide?

조회 수: 2(최근 30일)
Anne 2013년 11월 1일
댓글: Anne 2013년 11월 1일
Ok, so I have read many posts on this subject, but I cannot figure out how to make it work in my case. I use a NI device to collect data and want to use Guide to make a control panel for this. So I have created a session within guide and defined all the parameters. I included a listener as follows:
handles.lh = handles.s.addlistener('DataAvailable',@(src,event) SaveDataNIDevice(src,event,handles));
Within SaveDatNIDevice function I use a plot command to plot the data. This works well with the exception that a new figure is created to plot the data. I want to have this figure within axes defined in Guide figure. How do I do this?

채택된 답변

Doug Hull
Doug Hull 2013년 11월 1일
plot(hAxes, WHATEVER you were plotting before)
This will force plot to use the axes refered to by the handle hAxes.
  댓글 수: 1
Anne 2013년 11월 1일
I guess the solution was much simpler than I thought. I did try this before but apparently the session was not closed properly causing lots of erros. Anyway thanks!

댓글을 달려면 로그인하십시오.

추가 답변(0개)


Find more on Migrate GUIDE Apps in Help Center and File Exchange


Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by