how to program an ardunio duemilanove using simulink ?

조회 수: 3 (최근 30일)
vivek panchal
vivek panchal 2013년 10월 29일
댓글: Javier Triveno 2015년 2월 21일
hello, i have a arduino duemilanove with ATMEGA328 controller. when i connect arduino pc and run on target hardware this error occurs "The call to realtime_make_rtw_hook, during the entry hook generated the following error:" and nothing happend.

답변 (2개)

Rolfe Dlugy-Hegwer
Rolfe Dlugy-Hegwer 2013년 11월 10일
Sorry, but Duemilanove is not supported. Please try using Arduino Uno, Nano, or Mega2560.

Nicholas
Nicholas 2014년 3월 15일
Rolfe, I have been programming an Uno board with Simulink and I have recently purchased a nano v3.0 for a replacement. How do you select a nano when going to put your program on the nano in simulink? Mine only allows an uno and a mega?
Thanks
  댓글 수: 2
Jose Laruta
Jose Laruta 2015년 2월 18일
i have the same problem, with MATLAB R2013a, please help
Javier Triveno
Javier Triveno 2015년 2월 21일
Jose, I change the target hardware to nano 3.0 and works.

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Modeling에 대해 자세히 알아보기

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by