Feeds
질문
R2013a 64 Bit + Stateflow + Simulink + MinGW + Gnumex = working?
Hi, I wonder if I can use the combination of mentioned programs under Windows 7 64Bit? Does Stateflow work? I have serious...
12년 초과 전 | 답변 수: 0 | 0
0
답변답변 있음
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...
Closed kinematic system assembly error (SimMechanics Second Generation)
I had the same problem and solved it by looking concentrated at the coordinate systems for hours. Then I changed a single digit ...
12년 초과 전 | 0
질문
Measure reaction forces in joints and bearings
Hi! I built a model in SimMechnics 2G. It seems to work quite good :) Is there a way to measure the reaction forces or the...
12년 초과 전 | 답변 수: 1 | 0
1
답변답변 있음
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...
How to connect with breadboard and matlab
you could get an arduino or raspberry pi, a dc-power-source (12v-battery for example), some mosfet-circuitry and a sensor to mea...
12년 초과 전 | 1
| 수락됨
문제를 풀었습니다
Make the vector [1 2 3 4 5 6 7 8 9 10]
In MATLAB, you create a vector by enclosing the elements in square brackets like so: x = [1 2 3 4] Commas are optional, s...
12년 초과 전
문제를 풀었습니다
Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...
12년 초과 전
질문
More information about assembly (or why is something not assembling)
Hi, I wonder if there are more tools in SimMechanics 2G than the Explorer who simply states: Joint x ist bad. For example, so...
12년 초과 전 | 답변 수: 1 | 0
1
답변질문
How to interface Stateflow charts with Bus signals
Hi, In my model a stateflow chart has a lot of inputs and outputs. Is it possible to feed a bus signal directly into or ou...
12년 초과 전 | 답변 수: 2 | 0
