Feeds
질문
Droplet plotting on x-y plane
The code below creates a movie which shows the growth of a droplet. This is done by reading a text file that contains 3 columns ...
대략 5년 전 | 답변 수: 1 | 0
1
답변질문
Plotting on a curved surface
This question may be a bit vague but is there anyway to plot these droplets (i.e. the red dots) on a curved surface. All coordin...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
How to plot a quarter of a circle
This question is most likely too vague to answer, but I am trying to plot the geometry of a quarter circle and am not too sure w...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
Writing into .txt file
I have currently created two separate matrices both [500x1] and am trying to write them into one .txt file but it is not working...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
How to store data
I am trying to store data for variables x, y, r and theta but am not sure how to do it. Any help would be greatly appreciated a...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
Storing error values every iteration
I need to store the error value after every completed iteration. I've tried to do this using the following section of code, howe...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
Storing error values in for loop
I'm sure this is a pretty simple for loop but I'm trying to store the error value for each iteration performed in my code but no...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
Index in position 1 exceeds boundaries
I have just written a code for a heat transfer problem and when I run it I get an error stating 'Index in position 1 exceeds bou...
5년 초과 전 | 답변 수: 1 | 0
1
답변질문
Running Matlab simulation from a C++ code
I have inhereted a C++ code (source and header files) and am wondering how I would run a simulation based of the data obtained f...
5년 초과 전 | 답변 수: 1 | 1
1
답변질문
Relative Displacement and Velocity
I have derived my equations of motion and have managed to plot both of the individual velocities, but I would also like to h...
대략 6년 전 | 답변 수: 1 | 0
1
답변질문
Entering state space model into matlab and using ode45 for non-linear thrust force
I'm doing an assignment and haven't really used MATLAB before. Firstly, I have put the equations of motion into state space form...
대략 6년 전 | 답변 수: 0 | 0
0
답변질문
Program output is correct but not plotting anything
I've written a program in MATLAB that prints data that is correct but when I attempt to plot these values nothing comes up.
대략 6년 전 | 답변 수: 1 | 0
