Community Profile

photo

Nick Van Oosterwyck


University of Antwerp

Last seen: 1일 전 |  2021년부터 활동

Followers: 0   Following: 0

I am a PhD researcher at the University of Antwerp, currently working on the development of a CAD-enabled a priori and online trajectory optimisation for repetitive movements, advised by professors Stijn Derammelaere and Annie Cuyt. While in grad school I discovered I am fascinated by robots and mechatronics, especially those used in an automated production environment. From this interest, I try to conduct further research into more efficient and performant systems. I also enjoy teaching and guiding theses.

통계

All
  • Personal Best Downloads Level 1
  • First Submission
  • Knowledgeable Level 1
  • First Answer
  • Solver

배지 보기

Feeds

보기 기준

답변 있음
Tolerances are relative or not in interior-point for fmincon?
You can also get an overview of all the algorithms and whether the tolerances are relative or absolute on: https://www.mathwork...

대략 1년 전 | 0

제출됨


hemisphere
Create hemisphere

대략 1년 전 | 다운로드 수: 5 |

Thumbnail

제출됨


hemicylinder
Generates cylinder with hemispherical ends.

대략 1년 전 | 다운로드 수: 1 |

Thumbnail

답변 있음
Incorrect logarithmic axes after setting 'defaultAxesNextPlot' to 'add'.
When you enable hold on with set(groot,'defaultAxesNextPlot','add'), the figure and axes properties become locked. Thus, because...

거의 2년 전 | 1

| 수락됨

문제를 풀었습니다


Times 2 - START HERE
Try out this test problem first. Given the variable x as your input, multiply it by two and put the result in y. Examples:...

2년 초과 전