Community Profile

photo

Rick Hyde

Last seen: 17일 전 |  2021년부터 활동

Followers: 0   Following: 0

통계

  • Knowledgeable Level 2
  • First Answer

배지 보기

Feeds

보기 기준

답변 있음
how to put input value for FEM-Parameterized Linear Actuator (.1)Flux partial derivative wrt current, dPhi(i,x)/di (unit is web/A )2)Flux partial derivative wrt displacement)
MATLAB provides lots of ways for you to determine partial derivatives from the flux. One way, for example, is to fit a polynomia...

대략 1개월 전 | 0

| 수락됨

답변 있음
Check Thyristor Holding Current in Simscape model
The holding current will depend on the NPN and PNP transistor I-V characteristics which, in-turn, depend on forward gain, forwar...

9개월 전 | 1

| 수락됨

답변 있음
How to generate the proper PWM Signal to control the Simscape RC Servo Block
An RC Servo contains its own controller that sets the output angle. The angle set set by the pulse period of the voltage applied...

대략 2년 전 | 0

| 수락됨

답변 있음
Reconstruct SIC MOSFET switching losses out of datasheet - simscape model has a big deviation
Hi Florian Root cause of your difficulties here is that the datasheet does not give you everything you need to accurately predi...

2년 초과 전 | 1

| 수락됨

답변 있음
Add dead time in Simulink
We now have the Gate Driver and Half-Bridge Drive blocks in Simscape™ Electrical™ which allow you to specify dead-time/blanking ...

2년 초과 전 | 1

| 수락됨

답변 있음
Solver for common mode noise
For Simscape models, you should in general choose an implicit solver e.g. ode23t, ode15s or daessc. However, results should be c...

3년 초과 전 | 0

| 수락됨