Why is there an error displayed on my target machine after I boot the machine using the boot disk created by my host machine using xPC Target 2.5 (R14)?

Question

MathWorks Support Team 2009년 6월 27일

0
링크

이 질문에 대한 바로 가기 링크

https://kr.mathworks.com/matlabcentral/answers/94455-why-is-there-an-error-displayed-on-my-target-machine-after-i-boot-the-machine-using-the-boot-disk-cr

편집: MathWorks Support Team 2014년 2월 25일

채택된 답변: MathWorks Support Team

I create the boot disk and booted the target machine and see the following errors:

ERROR: -4: drive not found

or

No accessible disk found: file system disabled

이 질문에 답변하려면 로그인하십시오.

Answer 1

MathWorks Support Team 2013년 10월 18일

0
링크

이 답변에 대한 바로 가기 링크

https://kr.mathworks.com/matlabcentral/answers/94455-why-is-there-an-error-displayed-on-my-target-machine-after-i-boot-the-machine-using-the-boot-disk-cr#answer_103807

The xPC Target 2.5 (R14) has a new feature which supports writing real-time data to a disk file on the target system also called File Scope. This feature is limited to IDE hard drives formatted in FAT. Hard drives formatted in NTFS or hard drives that use other interfaces (such as SCSI or DiskOnChip) are not supported currently. The error message indicates the inability of the kernel to locate a FAT hard disk. It can be safely ignored, if you do not plan on using the File Scope feature.