How do I implement a DC current source in SimPowerSystems?
조회 수: 3 (최근 30일)
이전 댓글 표시
MathWorks Support Team
2011년 4월 14일
편집: MathWorks Support Team
2022년 10월 14일
I would like to implement a DC current source in SimPowerSystems. The documentation of the AC Current Source block states the following:
A zero frequency specifies a DC current source.
However, when I insert an AC Current Source block and set the frequency to 0 Hz, the output current is always 0 A, regardless of what I enter as the peak amplitude.
채택된 답변
MathWorks Support Team
2022년 10월 14일
편집: MathWorks Support Team
2022년 10월 14일
This bug has been fixed in Release 14 Service Pack 2 (R14SP2). For previous releases, please read below for any possible workarounds:
You can implement a DC Current Source in SimPowerSystems in one of two ways:
1. Insert an AC Current Source block into your model
Set the Peak Amplitude parameter to the DC current and set the phase to either 90 degrees or -90 degrees, depending on the direction you want current to flow.
A reference to this can be found in the following link (AC Current Source-> Description)-
2. Insert a Controlled Current Source block into your model
Change the Source type parameter to DC and connect the input port with a Constant block that contains the value of the DC current.
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Sensors에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!