How to store nonlcon value at solution using fmincon?
조회 수: 1 (최근 30일)
이전 댓글 표시
Vinicius Belarmino Almeida
2021년 8월 4일
댓글: Vinicius Belarmino Almeida
2021년 8월 4일
Hi everyone,
Pretty much the question on the title. I am using fmincon to solve an optmization problem with several non linear constraints. I would like to know which constraint was active at the solution point, and its value if possible.
I know it's possible to use OutputFcn to call a function in each iteration, but I would prefer not to, as I only want the value at the solution point.
Many thanks,
Vinicius Almeida.
댓글 수: 0
채택된 답변
Walter Roberson
2021년 8월 4일
편집: Walter Roberson
2021년 8월 4일
fmincon() is permitted to evaluate at locations without passing that exact location through the nonlinear constraints before or after the evaluation. Therefore recording the results of the nonlinear constraint is not certain to give you the correct answer.
Instead, after you are given the location at the end, pass the location into the nonlinear constraint function yourself, and look at the results.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Get Started with Optimization Toolbox에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!