Simulink powergui block error
조회 수: 140 (최근 30일)
이전 댓글 표시
Hi there, I am new to Simulink, I am working on a circuit for my assignment. But when I try to run it, it gives me a powergui error. I have attached the file in the link. Can someone please tell me what I am doing wrong? Or maybe fix it?
Error in 'new/A': Initialization commands cannot be evaluated.
Caused by:
The diagram must contain a powergui block. The block must be named powergui and should be located at the highest level of your diagram where SimPowerSystems blocks are found.
댓글 수: 3
채택된 답변
Ali yaylaci
2013년 8월 21일
편집: Ali yaylaci
2013년 8월 28일
If you do not place a powergui block (under the Simpower system) at the top level of your model you will encounter with this problem...
The Powergui block is necessary for simulation of any Simulink model containing SimPowerSystems™ blocks. It is used to store the equivalent Simulink circuit that represents the state-space equations of the model.
댓글 수: 1
andy
2014년 9월 24일
we have similar problem, we already put "powergui" block on the highest level, but still show the error.
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/181336/image.png)
추가 답변 (2개)
Roba Alghamdi
2023년 10월 20일
I cannot find powergui in my matlab also the electrical libar
댓글 수: 1
Joel Van Sickel
2024년 6월 10일
this is the block. If you cannot find it, you don't have simscape electrical installed.
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Sensors에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!