DC-DC Buck-Boost Converter Closed Loop PWM control

조회 수: 2 (최근 30일)
Can Yilmaz
Can Yilmaz 2021년 5월 7일
답변: Sabin 2024년 1월 21일
Hi friends,
I have a buck boost converter that increase the voltage 10 to 15 shown below.
I think that is working. But when I need to add PWM control doesnt work.
Can you help me whats the wrong ? I added to powergui(continous) btw
thx

이 질문에 답변하려면 로그인하십시오.

답변 (1개)

Sabin
Sabin 2024년 1월 21일
The proportional control employed is not working properly. The controller is very basic, multiplying the error with a constant but the output of the controller is probably not normalized to the same range as the sawtooth generator. See this example for a starting point:
https://www.mathworks.com/help/sps/ug/inverting-topology-buck-boost-converter-control.html

카테고리

Help Center 및 File Exchange에서 Electrical Block Libraries에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by