dbstop if error: manually fixing the error and continue?

조회 수: 56 (최근 30일)
covariant_cat
covariant_cat 2013년 7월 1일
Hi all,
Let's say I toggle on the dbstop if error. And the matlab automatically stops at the error, is it possible for me to manually fix the error and continue the code execution (right from the place where Matlab stops, instead of re-running the code from the beginning)?
Thanks in advance!
Best, Liao

채택된 답변

Jan
Jan 2013년 7월 2일
The documentation of dbstop is clear in this point:
dbstop if error — Run-time error that occurs outside a try/catch block. You cannot resume execution after an uncaught run-time error.

추가 답변 (2개)

Youssef  Khmou
Youssef Khmou 2013년 7월 1일
hi,
Yes, if you put the command dbstop if error at the top of the M-file and run your code, when the compiler finds the error, the cursor indicates the line , then your press "F5", fix the error and re run, repeat the process until the code is error-free .
  댓글 수: 3
Youssef  Khmou
Youssef Khmou 2013년 7월 1일
ok
You go to the menu of the M-file page, you click on cell and then enable cell mode , next you divide your code into parts using the notation %% in the beginning and end of each part, then this when a cursor is placed somewhere in specified cell, you click on evaluate cell in top right .
I hope this is clear,
More information can be found in the following page : http://blogs.mathworks.com/community/2009/06/08/using-the-cell-mode-toolbar/

댓글을 달려면 로그인하십시오.


per isakson
per isakson 2013년 7월 1일
편집: per isakson 2013년 7월 1일
AFAIK: The answer is NO. It is not possible.
However,
  1. you can fix the line, but don't save
  2. select the line, right-click and Evaluate Selected (F9) to ensure that the fix works
  3. select lines before and after the fixed line and Evaluate Selected
But eventually you must save and re-run.

카테고리

Help CenterFile Exchange에서 Debugging and Analysis에 대해 자세히 알아보기

제품

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by