The error message you're encountering, "Invalid ConsecutiveZCsStepRelTol specified in the Configuration Parameters dialog for block diagram," suggests that there is an issue with the zero-crossing control parameters in your Simulink model configuration.
The solver 'Type' should be set to 'Variable-step' and then you should set the 'Zero-crossing control' option to either 'Use Local settings' or 'Enable all' to change the Time Tolerance parameter. This option enables zero-crossing detection for all blocks in the model that register zero crossings regardless of the parameter setting on each block.
Also, the value ConsecutiveZCsStepRelTol should be a small positive number. If it is set to a non-positive value, this could cause the error you're seeing.
For further information, refer to the documentation links below:
