MATLAB Answers

Executing Triggered/Enabled Subsystem

조회 수: 2(최근 30일)
Mashrur Alam
Mashrur Alam 2021년 3월 31일
답변: Jonas 2021년 4월 1일
I am working on a model that is code generates SW to run on a TI micro. This model has a stateflow diagram that controls the state of the SW (init, enabled, disabled, etc.) I want the Stateflow diagram to excecute a subsystem when it transitions from one state to another (or just excecute a subsystem when it enters a new state). I know that Stateflow can trigger function calls but I do not know how. I also don't know if I should be using a triggered or enabled subsystem.
I have tried using a "Simulink Function" block but my code gen process does not support this. So I will have to stick with subsystems.


Jonas 2021년 4월 1일
Use a Function Call Subsystem. In your Stateflow chart, use an Event and execute that on a state transition. Set the type of the Event to 'Output' and link it to the Function call port.




Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by