Is it possible to override the mex32 check during code generation?

조회 수: 2(최근 30일)
Matlab 2007a, Simulink 6.6.1
I have run into a situation where we have an s-function(mex32) generated from some source code. The code was later updated but the mex32 was not (mistakenly). However, during code generation there were no errors, and no warnings. The code crashes and we traced the problem to the misaligned mex32/source code.
Is there a way during code generation to override the mex32 with the source code, or not use the mex32 in the code generation?
  댓글 수: 3
Kaustubha Govind
Kaustubha Govind 2013년 6월 14일
No, I meant the "Support non-inlined S-functions" checkbox on the Interface pane. I'm confused about how the generated code calls into the MEX-file, could you paste the call to it from the generated code?

댓글을 달려면 로그인하십시오.



Find more on Simulink Coder in Help Center and File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by