how to use surge arrester block of simpower system
조회 수: 12 (최근 30일)
이전 댓글 표시
I'm right now making a simulation regarding the switching surges in our 23kV distribution network. The first problem i encounter are the parameters of the surge arrester namely Vref, Iref, K1, alpha1...and so on. Can you tell me how to get these values. Is it ok not to change the k and alpha values since the HELP says that these values are derived from commonly used arrester? We are using a normal duty arrester with MCOV of 15.3kV and 18kV operating voltage. I also attached the voltage-current curve of the said arrester.
I tried the compute for the values of the parameters using the curve but i can't determine if I'm doing it right. Hope someone can tell me the right way of determining the parameters. Thank you very much in advance
댓글 수: 1
Ram Patil
2016년 1월 14일
Please incorporate rated voltage of surge arrester as (Vref)(for this exceptional case) of 22 kV system. here number of columns must be one only. For (Iref) please insert reference current i.e. leakage current of Arrester at MCOV. For 22 kV system Arrester leakage current must be less than 5 mA. Regarding Segment Characteristics, dont change these parameters as this is non linear block & there will not be more change.
답변 (1개)
Joel Van Sickel
2021년 8월 18일
Copying Ram's post into the answer section.
Please incorporate rated voltage of surge arrester as (Vref)(for this exceptional case) of 22 kV system. here number of columns must be one only. For (Iref) please insert reference current i.e. leakage current of Arrester at MCOV. For 22 kV system Arrester leakage current must be less than 5 mA. Regarding Segment Characteristics, dont change these parameters as this is non linear block & there will not be more change.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Simscape Electrical에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!