How to keep same time range when sending data form Simulink to Matlab?
조회 수: 1 (최근 30일)
이전 댓글 표시
hi, I am Simulating a model in simulink and want to plot a graph of the output in MatLAB, but when i send it to MatLAB the time range changes, for example, when its in Simulink, its 300 seconds but when sent to MatLAB its 1200 seconds, basically I want the same response from the scope only in MatLAB.
Thanks
Johnny
댓글 수: 0
채택된 답변
Fangjun Jiang
2011년 5월 2일
I suspect you are viewing partial of your curve in Simulink scope. See this post: http://www.mathworks.com/matlabcentral/answers/5591-scope-time-not-shown-to-full-simlation
You may have ploted your curve in Matlab without time so your x-axle is just number of data samples. By default, the simulation time is sent to the workspace as "tout", so try, plot(tout, YourVariable). You can change this by click menu:
Simulation-> Configuration parameters ... -> Data Import/Export
댓글 수: 4
papan dey
2013년 2월 6일
i have generated simulink figure and can convert it in matlab using plot(signal) . now if i want to take the graph between a time limit such as 0.2s t0 0.5s, which command should i write?
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Sources에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!