# how to apply the monte carlo (MC) method on my BPSK_TX_RX code?

조회 수: 27(최근 30일)
adriane duarte 2020년 10월 5일
I made this code and I would like some help to apply the Monte Carlo (MC) method in this programming.
Help me!!!
the code follows below:
% BPSK
M = 2;
% número de bits ou símbolos
N = 1000000;
% transmissor
% Gera bits aleatórios ( matriz de variaveis binarias)
Bits_ale = randi([0 M-1],1,N);
% Modulação BPSK 0 -> -1; 1 -> 1
Bits_bpsk = 2 * Bits_ale-1;
% Gera bits de marca d'água aleatórios
Bit_wat = randi([0 M-1],1,N);
Theta = pi/8;
b = 1/sqrt(2)*(randn(1,N) + 1i*randn(1,N)); % white gaussian noise with 0dB variance
Eb_N0_dB = 0:20; % multiple Eb/N0 values
for k = 1:N
if Bit_wat(k)==1
Bit_enviado(k) = Bits_bpsk(k) * exp(1i * Bits_bpsk(k) * Theta);
else
Bit_enviado(k) = Bits_bpsk(k) * exp(-1i * Bits_bpsk(k) * Theta);
end
end
for iter = 1:length(Eb_N0_dB)
d = Bit_enviado + 10^(-Eb_N0_dB(iter)/20)*b; % additive white guassian noise
% receiver - hard decision decoding
ipHat = real(d)>0;
% counting the errors
nErr(iter) = size(find(Bits_ale- ipHat),2);
end
simBer = nErr/N; % simulated ber
theoryBer = 0.5*erfc(sqrt(10.^(Eb_N0_dB/10))); % theoretical ber
% plot
close all
figure
semilogy(Eb_N0_dB,theoryBer,'b.-');
hold on
semilogy(Eb_N0_dB,simBer,'mx-');
axis([0 10 10^-5 1])
grid on
legend('theory', 'simulation');
xlabel('Eb/No, dB');
ylabel('Bit Error Rate');
title('Bit error probability curve for BPSK modulation');
hold on
grid on

댓글을 달려면 로그인하십시오.

### Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by