Implementing a force/torque sensor in the second generation of SimMechanics
조회 수: 1 (최근 30일)
이전 댓글 표시
I am trying to implement a force/torque sensor in the second generation of SimMechanics (2012b). For this I am currently using a 6-DOF Joint with a Spring Stiffness of 300000 N/m in all internal mechancis and sense the positions to recreate the forces and torques.
But this method slows down the simulation quite a bit. In the first generation of SimMechanics, there was the possbility to use the Joint Sensor to get the reaction forces.
Question: Is there a better way to implement a force/torque sensor in the second generation of SimMechanics?
Best regards,
Jens
댓글 수: 1
jone
2014년 2월 27일
Hi, This is very similar to my problem I want to measure contact force between two bodies last thing I tried to model force/torque using simmechanics like you did but I have some problems doing that If you can help me that would be great
thanks a lot
답변 (2개)
pietro
2013년 4월 30일
Hi,
I have a similar problem. Did you get the relative displacement between the two frames which the joint is connected? If yes, how did you do that?
Cheers
Pietro
댓글 수: 1
jone
2014년 2월 27일
Hi, This is very similar to my problem I want to measure contact force between two bodies last thing I tried to model force/torque using simmechanics like you did but I have some problems doing that If you can help me that would be great
thanks a lot
참고 항목
카테고리
Help Center 및 File Exchange에서 Assembly에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!