Matlab 2019b don't recognise "Data Acquisition Commands"

I have been trying to connect NI USB 6009 to Matlab 2019b

Session base commands are recognised

I want to send Digital OUT signal ,but the "Session Commands" to ON or OFF Digital Output i cannot figure out

When i use these commands ,its working

d = daq.getDevices;
s = daq.createSession('ni');

sig = addDigitalChannel(s,'Dev1','port0/line0','OutputOnly');

signalData = sin(pi/2);

startBackground(s);

Following Messages i have

I want to use Data Acquisition Following are the commands i want to use , but the Matlab dont recognise them;

>> d = daqlist("ni")
Unrecognized function or variable 'daqlist'.
 
>> d = daqlist("ni")
Unrecognized function or variable 'daqlist'.
 
>> daq("ni")
Unrecognized function or variable 'daq'.

I have already checked the Data Acqusition Toolbox is installed. but Data Acqusition Commands are not recognisable.

Answer 1

[Walter Roberson]

daqlist is new in R2020a

For clocked operations see https://www.mathworks.com/matlabcentral/answers/270638-how-do-i-share-a-clock-between-unclocked-digital-inputs-and-clocked-analog-inputs#answer_212066

[Hassan Mehmood Khan]

The artcile was not of so help

I am sorry i am very new to DAQ in Matlab.

I only want to turn on and off digital IO using NI USB 6009

I am using the code below

d = daq.getDevices;
s = daq.createSession('ni');

s.Rate = 5;

oneCycle = 1;
addDigitalChannel(s,'Dev1','port0/line0','OutputOnly');

outputSingleScan(s,oneCycle);

[Walter Roberson]

The article says clearly that you cannot use startForeground or startBackground with digital pins for a fair number of National Instrument DAQs, and that even for the ones that permit using those calls, that it is often restricted as to which pins can be used.

The NI USB 6009 is a fairly low-end model. You probably cannot use the calls with any of the digital pins for the USB6009.

Using outputSingleScan is the way to proceed for the digital pins.