Is it necessary to perform a load flow prior to run the power_3levelVSC file?
조회 수: 1 (최근 30일)
이전 댓글 표시
Juan Antonio Cabeza López de Tamayo
2020년 6월 7일
댓글: Juan Antonio Cabeza López de Tamayo
2020년 6월 13일
Good afternoon, in this file a PWM converter is connected to a grid. My question is whether it is necessary or not to perform a load flow before simulating this file.
If not could you please suggest other cases where a previous load flow is required to set the values of the blocks? Thanks in advance!
Juan Cabeza
jaca1810eng@gmail.com
Research Gate: Juan Cabeza
Twitter: @jaca1810eng
댓글 수: 0
채택된 답변
Joel Van Sickel
2020년 6월 8일
Hello Juan,
due to the power electronics involved and how they are modelled in this model, the load flow option would not work. Instead, this model was run to steady state, and those states were saved and then put in as initial conditions.
Here are some models that use load flow. Unfortunately, if your main goal is the power electronics simulation, this type of work flow won't be useful for you.
Regards,
Joel
추가 답변 (0개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Power and Energy Systems에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!