Using the first value of a variable during simulation in Simulink

조회 수: 1 (최근 30일)
Berke Ogulcan Parlak
Berke Ogulcan Parlak 2020년 6월 2일
답변: Fangjun Jiang 2020년 6월 2일
This block generates output only once during simulation (at the beginning of the simulation). And I want to use the output obtained initially throughout the simulation. I tried to use Unit Delay, but I think I have to add something. Could you help?

이 질문에 답변하려면 로그인하십시오.

채택된 답변

Fangjun Jiang
Fangjun Jiang 2020년 6월 2일
If the triggered subsystem is truly ran only once, then you don't need to do anything. The output value of this block is "held". Just try it.

추가 답변 (0개)

카테고리

Help Center 및 File Exchange에서 Schedule Model Components에 대해 자세히 알아보기

태그

제품


릴리스

R2019b

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by