simscape noise on scope display

Hello , i have tried to display my DC with noise signal into a scope using PS-simulink converter but as you can see bellow.

its not connecting.

Where did i go wrong?

Thanks.

Answer 1

[Sabin]

This is not ho physical blocks are working. Think about a real-world system where you have a DC voltage source. To display the voltage you will need a Voltage Sensor. It is not possible to connect directly Simulink blocks to domain specific signals blocks. Simulink can interact with physical systems via sensors and controlled sources (must have a PS input or output). I suggest taking the Circuit Simulation Onramp:

https://matlabacademy.mathworks.com/details/circuit-simulation-onramp/circuits