- Connect the output pin to the base of an NPN Bipolar Transistor or PNP Bipolar Transistor block.
- Set the Output resistance parameter to a suitable value.
How is it possible to have a open collector comparator?
조회 수: 3 (최근 30일)
이전 댓글 표시
Hi, I just need an LM2903 type op comparator, wich is open collector output.
The simscape Electrical - Integrated circuit library has a comparator avaible, but the open collector output are not avaible.
How can I configure it?
I was wondering to add a transistor at the output, but I hope there's another solution.
Thanks
댓글 수: 0
채택된 답변
Joel Van Sickel
2020년 8월 5일
Hello Federico,
if you have a spice model of the part, you can import that into simscape, and at that level of fidelity, it should include the open collector aspect (although there are no standards for vendor provided PSPICE models so you should verify).
To import a spice model, please use this documentaiton: https://www.mathworks.com/help/physmod/sps/ref/subcircuit2ssc.html
Otherwise, you will have to follow the recomendations in the comparator help file as you suspected. I have posted them here:
Modeling of the output as a controlled voltage source is representative of a totem-pole or push-pull output stage. To model a device with an open-collector:
Regards,
Joel
댓글 수: 0
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Electrical Sensors에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!