Is SDRuReceiver support N321?

Hi,

I am trying to run SDRuReceiver command with platform 'N321' (or 'N320/N321') but I got the following error.

Error using comm.internal.SDRuBase

"N320/N321" is not a valid value for the Platform property. Valid values are: "B200" | "B210" |

"N200/N210/USRP2" | "X300" | "X310".

However, as mentioned in the link below N321 is a supported board for this command.

https://www.mathworks.com/help/supportpkg/usrpradio/ug/comm.sdrureceiver-system-object.html

Please let me know if you have any suggestions.

Thanks

[chengmao Zhou]

Hello,I want to use N321 in matlab too.But I have some problems when I setup the N321.Did you successfully set up N321?

[Mohammad Torabi]

Hi, I did not use Matlab anymore, just the UHD.

Answer 1

[Sai Sri Pathuri]

The support for USRP N320/321 radio is introduced in R2020a. You may see the R2019b documentation below. N320/321 was not listed in Platform.

https://www.mathworks.com/help/releases/R2019b/supportpkg/usrpradio/ug/comm.sdrureceiver-system-object.html#bun592c-1-Platform

I assume you are using an older version of MATLAB and the error might be because of that. You may upgrade to R2020a to use N321 radio.

[Mohammad Torabi]

Thanks for your reply.

Yes, you are right, I am using R2019 version. I will upgrade to R2020 and if I had a question I will let you know.

[chengmao Zhou]

Hello,I want to use N321 in matlab too.But I have some problems when I setup the N321.Did you successfully set up N321?