How to set threshold to trigger for start and stop finding max value?
조회 수: 4 (최근 30일)
이전 댓글 표시
Hi all,
I am measuring flowing particles with a system. The particle will start to induce a pulse signal once it just enters the sensing zone, and the max amplitude can be obtained around the center of the zone.
What I have considered method by used for and if function is :
- Set a threshold for switch on and switch off record the data
- Once the amplitude (y>threshold) which means the cell just enter the sensing zone, start the search
- When the amplitude (y<threshold) which means the cell almost leave the zone, stop searching
- Find the max value from this recording time interval
- Also get the time interval
However, I am quite fresh in MATLAB so don't know how to write down them...
Thanks if someone can help me design this tool!
댓글 수: 0
채택된 답변
Image Analyst
2020년 4월 17일
Can you post a diagram, plot, image, data or anything to help illustrate your situation?
Otherwise, just try find:
indexEnters = find(y > threshold, 1, 'first'); % Index when particle enters and signa becomes big enough.
indexLeaves = find(y > threshold, 1, 'last'); % Index when particle leaves and signa becomes small again.
댓글 수: 7
Image Analyst
2020년 4월 19일
편집: Image Analyst
2020년 4월 19일
xline() was introduced in r2018b. You can replace it with line():
line([ts(starts(k)), ts(starts(k))], ylim, 'Color', 'g', 'LineWidth', 2);
If anymore happen, just delete the line that threw an error. Most of them are just for making fancy graphics anyway.
I'll edit your post to add your Product on the right hand side of this page.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Extend Testing Frameworks에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!