F28379D-Simulink data monitoring: PWM signals

조회 수: 14 (최근 30일)
Praveen Kumar
Praveen Kumar 2019년 10월 30일
댓글: Mohammad Qaza 2023년 12월 27일
Hi,
I am learning to use TI F28379D interface with Simulink. I saw examples of data monitoring where voltage, currents data are monitored in simulink using external mode and C2000_host_read_12M example (not clear how works).
I would like to generate a PWM signal of certain freq and is it possible to monitor it in simulink? Since ePWM block doesnt have any output pin, I cant connect any scope. I could monitor the input in external mode.
  댓글 수: 1
Mohammad Qaza
Mohammad Qaza 2023년 12월 27일
Hi, I'm trying to do the same. have you been able to figure this out??
Thanks in advance.

댓글을 달려면 로그인하십시오.

채택된 답변

Venkatesh Chilapur
Venkatesh Chilapur 2019년 11월 4일
Hi,
Please check the below link for an idea on Host-Target SCI setup.
ePWM block act as driver block such that it can generate the code and run the same on the target. It has no simulation capability to show what output pattern will be generated. We can only see this output on a PWM pin on the hardware using DSO.
HTH,
Regards,
Venkatesh C

추가 답변 (0개)

카테고리

Help CenterFile Exchange에서 Pulse and Transition Metrics에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by