Finding a Signal from an noisy signal
조회 수: 3 (최근 30일)
이전 댓글 표시
I am having an signal as displayed in the image the red signal is the input and the blue one is outut as we can see that we have six peaks obtained in the input (Red) signal and the same should be present in the output (Blue) signal. I want to find the the signals in the blue samples. Is there any kind of filter or code which I can apply to find the signals.
Please note that signals attached in the image are created using an CSV file which contains the amplitudes of the signals.
댓글 수: 0
채택된 답변
Image Analyst
2019년 9월 2일
Simply use masking:
mask = redSignal > 0.1; % Logical index (mask) of where the red signal is higher than 0.1.
% Now replace those bad red signal locations with the good blue signal:
redSignal(mask) = blueSignal(mask);
댓글 수: 2
Image Analyst
2019년 9월 3일
Not sure what additional I can say. The green comment above say it all. The mask is where the red signal is higher than 0.1 (bad signal locations/indexes). And then I replace those bad red signal locations with the values from the good blue signal. Read it again and tell me where you see some ambiguity or uncertainty in what it says.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Author Block Masks에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!