Thermocouple measurement in Simulink Desktop Real-time using National Instrument devices
조회 수: 1 (최근 30일)
이전 댓글 표시
Hi,
I want to measure temperature using thermocouple . Currently I have NI-9211 module with chasis NI-cDaq-9174 using these I can get temperture in session based interface. Can I use these hardwares in Simulink Desktop real-time to get temperature and perform real time simulation? If not, then which NI device will be needed to take temperature reading using thermocouple.
Thanks a lot.
댓글 수: 0
채택된 답변
Roshni Garnayak
2019년 8월 22일
Simulink supports NI 9211 and NI cDAQ-9174 for versions R2016b and above.
To get a list of National Instruments hardware supported by MATLAB and Simulink, refer to the following link:
댓글 수: 2
Danny
2024년 2월 23일
That is correct regarding Real time Sync block, did you manage to select K type thermocouple in the Simulink Anolog Input block in Data Acquisition Toolbox Library? I can only find mV measurement on my NI9212.
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Real-Time Simulation에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!