Why do i get a different pzmap if i use idtf or ss representation of the same system
조회 수: 3 (최근 30일)
이전 댓글 표시
Hello,
I noticed a behaviour i cannot explain.
idtf, idpoly, ss, from what i understood, is just a matter of writing or convention to describe a system. Because they describe the same system, they should have the same poles and zeros, therefore the same pzmap.
I have a continuous SISO model. If i do pzmap of the ss, i get one pole of multiplicity N, the order of my system, and N zeros as well.
if i do pzmap of the idtf representing the same system, i get N poles and N zeros. Zeros do not match perfectly but are quite close.
Does anyone has an explanation?
Thanks in advance for your help
댓글 수: 0
채택된 답변
Raj
2019년 6월 19일
I assume you are doing something like this:
G = idtf(num,den)
M=tf(num,den)
N=ss(G)
Now you expect G ,M and N to be identical and have same pzmap since they are basically the same system. However there may be small differences due to numerical computation accuracy issues if your system is of high order.
See the section "Recommended Working Representation" here:
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Stability Analysis에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!