MCC DAQ driver warning
조회 수: 4 (최근 30일)
이전 댓글 표시
The following error shows up when I type
aout1 = analogoutput('mcc',1)
and hit enter.
Warning: Warning: Measurement Computing InstaCal version 5.85 or later is required, version 5.24 was detected. Some analog output signals will be incorrect
with this device. We strongly recommend an update to InstaCal version 5.85 or later.
The strange part is that I actually have InstaCal 6.24 installed on my computer. I don't know if this is relevant but I have two MCC DAQ boards on the PCI buses. Also, board 0 has 8 analog output channels and board 1 has 4. However, when I try to add channels after the warning is issued, I can only add 3 for either of the boards. Please HELP!
댓글 수: 2
채택된 답변
추가 답변 (2개)
Md. Ashfaque
2012년 8월 16일
댓글 수: 2
Walter Roberson
2012년 8월 16일
Hmmm -- this does not seem to explain why you were not able to add beyond 3 for the board with 8 channels ?
참고 항목
카테고리
Help Center 및 File Exchange에서 Hardware Discovery and Setup에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!