Simulink (switch)

I built 2 differential equations in Simulink (see attachment). How can I combine both of them using the switch block?

If x>-0.1, the upper one has to be my output and if x<-0.1, the lower one has to be my output.

Thanks in advance

Answer 1

[Jim Riggs]

This problem may be complicated since you have 2 different definitions of x. However, based on what you asked for, this should work.

The upper signal is passed through whenever f1(x) is greater than -0.1. If f1(x) <= -0.1, the lower signal is passed through.

Note that the switch will always use the value of f1(x) to determine which value to pass.