How should I set VREFHI in ADC in moicrocontroller of F28069M inside simulink\matlab and also In the form of hardware?

조회 수: 1 (최근 30일)
mohammad farahani
mohammad farahani 2018년 6월 23일
편집: mohammad farahani 2018년 6월 23일
Hello I use LAUNCHXL-F28069M. In model configuration, VREFHI has been set 3.3 volt inside simulink/matlab. and micro VREFHI pin has also been connected to launchpad 3.3 volt pin. But I recieve 3 volt as maximum volt on analog pin( which means that micro ADC gives 0 to 3 volts for 4096 digitdal level. What's the reason? On the other side, how could I set VREF externally?

이 질문에 답변하려면 로그인하십시오.

답변 (0개)

카테고리

Help Center 및 File Exchange에서 Instrument Control Toolbox에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by