Loading a Simhydraulic Motor
조회 수: 3 (최근 30일)
이전 댓글 표시
I'm working on a system where I will want to put a load onto a hydraulic motor so that the system will develop pressure. In the SImHydraulics package there appear to be two hydraulic motors, "Hydraulic Motor" and "Variable Displacement Motor". Both of these include under their assumptions "No loading on the motor shaft, such as inertia, friction, spring, and so on, is considered." This would seem to indicate that it is not possible to load a hydraulic motor, which doesn't really make sense. Am I misunderstanding this statement or is it not at all possible to load one of these motors?
If I wanted to create back pressure using a hydraulic motor is there another approach I should take?
Thank you, -Andrew
댓글 수: 0
채택된 답변
Guy Rouleau
2012년 6월 8일
The doc statement means that the Hydraulic motor itself does not include loads such mass spring and damping.
This means that you need to use blocks from the Mechanical section of the Simscape foundation to apply load, for example Torque Actuator, Rotational Spring, Inertia, etc...
See demos like "sh_hydraulic_transmission_secondary_control.mdl" or "sh_actuation_system_cartridge_valve.mdl" for example.
댓글 수: 0
추가 답변 (0개)
커뮤니티
더 많은 답변 보기: Power Electronics Community
참고 항목
카테고리
Help Center 및 File Exchange에서 Upgrading Hydraulic Models to Use Isothermal Liquid Blocks에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!