Arduino ReadDigitalPin all ones
조회 수: 3 (최근 30일)
이전 댓글 표시
Hi, I'm trying to connect an arduino to matlab to collect data from the digital pins. I am sending data to pin D3, but when I say readDigitalPin(a,'D3') in matlab it just gives me 1. My code is below, any advice would be appreciated.
if true
a = arduino('com8', 'uno');
t1 = 0;
dt=[];
dv=[];
tic
for i =1:500
i;
tic;
v = readDigitalPin(a,'D2');
dT = toc;
t1 = t1 + dT;
dt(i) = [t1];
dv(i) = [v]
pause(0.5)
end
end
댓글 수: 1
Walter Roberson
2018년 5월 4일
Have you put an oscilloscope onto the pin to verify that the value goes lower than the threshold at some point, and does so for longer than the hold time of the sampling hardware?
Is D2 configured as a continual read or is it configured as triggered by edge detection? If triggered then what are the reset conditions?
답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 MATLAB Support Package for Arduino Hardware에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!