필터 지우기
필터 지우기

Phase and Gain alignment

조회 수: 3 (최근 30일)
nauman
nauman 2018년 4월 8일
Hi all
I have simultaneously recorded data coming from three pre-amplifiers with same input applied to these pre-amps. After post analysis, i found that there are phase and gain differences among these outputs ( which should be zero in ideal case). I set one preamplifer output as reference and measure the phase and gain difference values of other two preamps with respect to this reference using "fft technique" for a typical frequency value.
Now question is how can i use these phase/gain difference values to align all three signals in software?
Note: Idea is to save these phase/gain coefficients permanently and multiply them with each corresponding preamplifier's outputs (excluding reference ) sample by sample for each acquisition so that inherent phase/gain difference b/w preamplifiers can be adjusted without modifying the electronics.
Thanks

답변 (0개)

카테고리

Help CenterFile Exchange에서 Matched Filter and Ambiguity Function에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by