No deploy to hardware button in simulink (using the F2837xD with ccsv6)

Hi All, I'm interfacing the TMS320F28379D with MATLAB 2016a using the ccsV6. I have several problems and I'm unable to generate code and interact with the hardware board (ControlCARD). In the configuration parameters toolbar I haven't the line : Code Generation system target file : ert.tlc and the tab Code Generation is absent.

Also in the simulink windows the deploy to hardware button is missing. I think something is missing but I don't know what. The device is well connected and the target configuration is OK. Maybe the setup is imcomplete????

Answer 1

[Gayatri Menon]

Hi,

If you are using TI C2000 Support Package, it requires MATLAB Coder, Simulink Coder and Embedded Coder to work. Please refer the below link for more information:

https://www.mathworks.com/hardware-support/ti-c2000.html

Could you please check if you have the above-mentioned products installed in your system.You could check this by executing the following commands in MATLAB command Window

>> ver

Thanks