Matlab simulink file shows following error Simulink does not have enough information to determine output sizes for this block. If you think the errors below are inaccurate, try specifying types for the block inputs and/or sizes for the block outputs.

function [Sa,Sb,Sc] = Control(Vga,Vgb,ika,ikb,Vsa,Vsb)
% I_ref=0;
% I_meas=0;
% Vga=0;
% Vgb=0;
Ts= 1e-04;
p= 2000;
Vdc=620;
R=0.8;
L=0.005;
g = 0;
v0 = 0;
v1 = 2/3*Vdc;
v2 = 1/3*Vdc + 1j*sqrt(3)/3*Vdc;
v3 = -1/3*Vdc + 1j*sqrt(3)/3*Vdc;
v4 = -2/3*Vdc;
v5 = -1/3*Vdc - 1j*sqrt(3)/3*Vdc;
v6 = 1/3*Vdc - 1j*sqrt(3)/3*Vdc;
v7 = 0;
v = [v0 v1 v2 v3 v4 v5 v6 v7];
% Switching states
states = [0 0 0;1 0 0;1 1 0;0 1 0;0 1 1;0 0 1;1 0 1;1 1 1];
persistent x_old 
% Initialize values
if isempty(x_old), x_old = 1; end

 g_opt = 1e10;
 x_opt=inf;

 % Read current measurements at sampling instant k

 for i = 1:7
 % i-th voltage vector for current prediction

 V1= real(v(i));
 V2=Imag(v(i));
  Iast1=(2*(Vsa)*p)/(3*((Vsa)^2+(Vsb)^2));
    Ibst1=(2*(Vsa)*p)/(3*((Vsa)^2+(Vsb)^2));
    % Current prediction at instant k+1
 ik1a = ( 0.9841)*ika + (1/R)*(1- 0.9841)*(V1 - Vga);
 ik1b = ( 0.9841)*ikb + (1/R)*(1- 0.9841)*(V2 - Vgb);
  % Cost function
 g = (abs(Iast1 -( ik1a)))^2 + (abs(Ibst1 -( ik1b)))^2;
 if (g<g_opt)
 g_opt = g;
 x_opt = i;
 end
 end
  x_old = x_opt;
 Sa = states(x_opt,1);
 Sb = states(x_opt,2);
 Sc = states(x_opt,3);

end

[siv1]

Did you get output?

if no let me know.

Answer 1

[Sabin]

Taking a quick look there are two changes that are needed to make this model run:

1) Line 38 in the MATLAB function should be (not uppercase 'I'): V2=imag(v(i));

2) Use a Data Type Conversion on each output of the cls MPC function before doing the NOT. Another Data Type Conversion is needed after the Mux block on the feedback line that is going to the 6 pulse VSC.

In addition line 28 (x_opt=inf) is problematic because if there is no feasible solution then the function will error at line 52 when will try to evaluate Sa = states(inf,1).

I hope this helps.