How to add a mask parameter to a simulink block

Hello everyone,

For the purpose of my internship, I need to automate the creation of the mask parameters on a Simulink block.

Do you know if there is any Matlab instruction to add a parameter to a simulink block?

I thought to use this instruction

        add_param('sys','parameter1','value1')

but unfortunately it works only for a block diagram, not for a single block.

thanks 4 reading

[TAB]

Do you want to only change the value of parameter or you want to add more *Parameter fields* in the block?

[grapevine]

Unfortunately, I have to add more *Parameter fields* in the block

Answer 1

[Kaustubha Govind]

You need to do a set_param on the block to set MaskVariables, MaskPrompts, MaskValues, etc.

[grapevine]

thanks a lot

it works great

get_param(gcb,'MaskVariables')