save as .fig

조회 수: 2 (최근 30일)
Henar Martín-Sanz
Henar Martín-Sanz 2018년 1월 8일
편집: Henar Martín-Sanz 2018년 4월 22일
I am trying to save a figure as .fig but I receive the following error in a pop up window: "Error using matlab.ui.Figure/horzcat Conversion to matlab.ui.Figure from char is not possible". I also see the following warning: | Warning: Inputs must be character vectors, cell arrays of character vectors, or string arrays. > In savefig In saveasfig (line 6) In saveas (line 140) In filemenufcn>localSaveExportHelper (line 216) In filemenufcn>localSaveExport (line 344) In filemenufcn (line 56) In filemenufcn>localSave (line 186) In filemenufcn (line 54)|
It happens both with 2014b and 2016b versions. I can save the figures as .eps or .jpg, but I need them as .fig. Any ideas?
Thanks!

답변 (1개)

Manan Mishra
Manan Mishra 2018년 1월 11일
편집: Manan Mishra 2018년 1월 11일
The error you are getting could be due to a shadowing issue.
You can try the following steps and see if this resolves the issue:
1. Execute the following commands in MATLAB command prompt:
>> restoredefaultpath
>> rehash toolboxcache
2. Trying saving the figure again.
3. If it works, save the default path.
>> savepath
  댓글 수: 1
Henar Martín-Sanz
Henar Martín-Sanz 2018년 1월 12일
편집: Henar Martín-Sanz 2018년 4월 22일
Hi,
The problem I have is that I am using a program, and I need to add certain toolboxes to the path when I start it:
addpath(genpath([matlabroot,'\toolbox\spice33-2014-07a'])) addpath(genpath([matlabroot,'\toolbox\sigfun-2008-10a']))
If I folow the steps you suggested, I can not use the program any longer, I guess because I loose the added toolboxes. I need to have the program open to save the figure. Is there any other way to solve this?
Thanks!

댓글을 달려면 로그인하십시오.

카테고리

Help CenterFile Exchange에서 Printing and Saving에 대해 자세히 알아보기

태그

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by