unsolved "initialization commands cannot be evaluated" error when trying to run simulink
조회 수: 3 (최근 30일)
이전 댓글 표시
I am using a R2011b matlab (32bits) which has a simulink demo "six-phase synchronous machine with pose-fault operating strategy". The six-phase syn motor is running fine with the mechanical power Pm as the mechanical input. However, whenever I switch the input to speed w, an initialization error prompts as:
Error due to multiple causes. --> Error in "Power 6phsyncmachine/Six Phase Synchronou Machine 240V 100KVA": Initialization commands cannot
be evaluated. --> Block choice 'Continuous' is not a valid member of 'Power 6phsyncmachine/Six Phase Synchronous Machine 240 100KVA/Mechanical model'
which is the cause?
Thank you!
Thank you!
댓글 수: 1
답변 (1개)
Joel Van Sickel
2021년 8월 18일
This appears to have been a bug in the library that has been resolved.
댓글 수: 0
참고 항목
카테고리
Help Center 및 File Exchange에서 Magnetic Elements에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!