필터 지우기
필터 지우기

How to model a slack(swing) bus in simuilink model?

조회 수: 17 (최근 30일)
Rula Sha
Rula Sha 2017년 11월 14일
편집: Nick Choi 2017년 11월 17일
As there is no slack bus element in simulink, how to device such a bus so that the voltage can be set, and the active and reactive power can change automatically according to different load conditions? My need to devise simple distribution systems which have five buses, they are all connecte in series. Four of them are connected with 4 identical loads, the first bus from electrical source should be a slack bus but I am confused that how to model it. Any suggestions are welcom.. Thank you.

답변 (1개)

Nick Choi
Nick Choi 2017년 11월 17일
편집: Nick Choi 2017년 11월 17일
The 'Load Flow Bus' block can be used to specify the parameters of a swing bus: https://www.mathworks.com/help/physmod/sps/powersys/ref/loadflowbus.html#bsumf1e-4
The following documentation page provides an example of how to use this block within a model of a 5-bus network:

카테고리

Help CenterFile Exchange에서 Modeling에 대해 자세히 알아보기

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by