- set the System Target as 'rtwsfcn.tlc',
- make sure "Create new model" is selected, and
- use the subsystem handle to call the 'rtwbuild' function like
How to generate a Simulink S-Function programmatically?
조회 수: 28 (최근 30일)
이전 댓글 표시
Hello, i have different Simulink models with lots of Subsystems in there. Some of these Subsystems must be generated as s-function. I was thinking about writing a script to generate the s-functions, but i don't found a function building s-functions programmatically. Is there any way?
댓글 수: 0
채택된 답변
Saurabh Gupta
2017년 7월 19일
You should be able to use a combination of instructions in the following two documentation sections to write a script that generates S-functions for you.
The high level idea is to
>> new_block = rtwbuild(subsystem_handle)
The 'rtwbuild' function will return the handle to the newly created S-function block, which you should be able to use to perform the intended operations on the new block (like replacing the sub-system with it or saving the block in a new model).
댓글 수: 2
Gordon
2017년 8월 24일
If the subsystem is connected to a bus-signal, this method won't work:
"The input to the Bus Selector block must be a virtual or nonvirtual bus signal.A possible cause of this error is the use of a bus-capable block"
When manually clicking "Build selected Subsystem" Simulink automatically creates two subsystems left and right to the s-function. Is there any way to programmatically (via script) trigger this process?
Thanks very much in advance!
Moritz Burghardt
2021년 9월 23일
You need to deselect the option "Generate Code only". You can do it programatically:
set_param(cs,'GenCodeOnly',0); % Deselect "Generate code only"
추가 답변 (0개)
참고 항목
카테고리
Help Center 및 File Exchange에서 Block and Blockset Authoring에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!