Question about the "enable" block.
조회 수: 2 (최근 30일)
이전 댓글 표시
Hi,
I have a little question about the enable block. If I have a enable block in a subsystem, what become my outputs when my subsystem is not enable ? And more specially when I have one output which is a bus ?
댓글 수: 0
채택된 답변
추가 답변 (2개)
Arnaud Miege
2011년 3월 18일
Have a read of Enabled Subsystems in the Simulink documentation, particularly the section Setting Output Values While the Subsystem Is Disabled. As far as I know, this works with busses as well.
HTH,
Arnaud
댓글 수: 0
Sébastien Malengé
2011년 3월 18일
댓글 수: 2
Guy Rouleau
2011년 3월 22일
Did you really read the section mentioned by Kaustubha? This is what you need. Note that it is available since MATLAB R2010a.
Kaustubha Govind
2011년 3월 23일
Guy: I think Sebastien's reply was to Arnaud's answer. My answer came later but got voted up, so it shows up higher.
참고 항목
카테고리
Help Center 및 File Exchange에서 Schedule Model Components에 대해 자세히 알아보기
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!